Apple PC Serial and Parallel Card - Manual (Page 28)

What you need
Before beginning the installation process, make sure you have all the
necessary parts: the PC Serial and Parallel Card and the peripheral flex
cable. You’ll also need a Phillips screwdriver and your PC Compatibility
Card user’s manual.
Installing the PC Serial and Parallel Card hardware
There are several steps to installing your PC Serial and Parallel Card
hardware:
m opening the computer
m opening the expansion card cover
m preparing the slots
m attaching the peripheral flex cable to the PC Compatibility Card
m inserting the PC Serial and Parallel Card
m attaching the peripheral flex cable to the PC Serial and Parallel Card
m replacing the expansion card cover
m replacing the computer cover
WARNING The installation of the PC Serial and Parallel Card is
technically complex. Unless you are comfortable installing components
inside computers, Apple recommends that you have the PC Serial and
Parallel Card installed by your Apple-authorized dealer (who may
charge a fee). If you attempt to install the card yourself, any damage you
may cause to your equipment will not be covered by the limited
warranty on your computer.
Do not attempt to install the card or connect the cables without first
reading this manual.
28 Chapter 3