Apple PC Serial and Parallel Card - Manual (Page 14)

What you need
Before beginning the installation process, make sure you have all the
necessary parts: the PC Serial and Parallel Card and the peripheral flex cable.
You’ll also need a Phillips screwdriver, your PC Compatibility Card user’s
manual, and a magazine that you can place the computer’s logic board on.
Installing the PC Serial and Parallel Card hardware
There are several steps to installing your PC Serial and Parallel Card
hardware:
m opening the computer
m preparing the slots
m attaching the peripheral flex cable to the PC Compatibility Card
m inserting the PC Serial and Parallel Card
m attaching the peripheral flex cable to the PC Serial and Parallel Card
m replacing the logic board
WARNING The installation of the PC Serial and Parallel Card is
technically complex. Unless you are comfortable installing components
inside computers, Apple recommends that you have the PC Serial and
Parallel Card installed by your Apple-authorized dealer (who may
charge a fee). If you attempt to install the card yourself, any damage you
may cause to your equipment will not be covered by the limited
warranty on your computer.
Do not attempt to install the card or connect the cables without first
reading this manual.
14 Chapter 2