SkyTrak 6042 Operation Manual - Manual (Page 177)

Test Procedures
175 Model 6042 Origin 2/04
IMPORTANT! Perform Steps 5 thru 9 with the engine rpm at idle.
Step 5
a. Keep the service brake pedal depressed.
b. Move the travel select lever to the (N) NEUTRAL position.
c. Take your foot off the service brake pedal. The
Stabil-TRAK light should remain ON and the front left tire
should remain off the ground.
Step 6
a. With the travel select lever in the (N) NEUTRAL position,
engage the parking brake switch.
b. Move the travel select lever to the (F) FORWARD
position. The Stabil-TRAK light should remain ON and the
front left tire should remain off the ground.
Step 7
a. With the parking brake switch ON, move the travel select
lever to the (N) NEUTRAL position.
b. Lower the boom to exactly 45°.
c. Frame sway the vehicle no more than 5° to the left.
d. Frame sway the vehicle back to 0°.
e. Frame sway the vehicle no more than 5° to the right.
NOTE: Observe that frame sway will be slower than normal
during this test.
f. The Stabil-TRAK light should remain ON and the front left
tire should remain off the ground. The front left tire should
not raise or lower during frame sway.
g. Frame sway back toward 0°, leaving the vehicle swayed to
the right approximately 1° to 2°.
Step 8
a. Depress the service brake pedal.
b. Disengage the parking brake switch.
c. With the range select lever in (1) FIRST gear, move the
travel select lever to the (R) REVERSE position.
d. Release the service brake pedal to deactivate the
Stabil-TRAK system.
Stabil-TRAK System Test Procedures
LOCKE
D M
O
DE
N
eut
ra
l T
e
st
P
a
rk
B
rak
e T
e
s
t