SkyTrak 6042 Operation Manual - Manual (Page 175)

Test Procedures
173 Model 6042 Origin 2/04
Test Procedures
To test the function of the Stabil-TRAK system, read the Stabil-TRAK
system test instructions on this page and follow steps 1 through 9 of the
Stabil-TRAK System Test Procedure.
Stabil-TRAK System Test Instructions
• Test the Stabil-TRAK system with the vehicle on a level surface.
• Remove any attachment from the quick attach before performing
the test.
• DO NOT extend the boom at any time during the test. Perform the
test with the boom fully retracted.
• DO NOT raise the boom above 60° for steps 3 through 6.
• DO NOT raise the boom above 45° for steps 7 through 9.
• Follow steps 1 through 9 of the Stabil-TRAK system test procedure
exactly as written.
If the Stabil-TRAK light goes OFF and the front left tire lowers to the ground
at any time during steps 4 through 7, the test was not performed properly or
the Stabil-TRAK system is not functioning properly. Carefully repeat the
steps starting with step 1.
If the Stabil-TRAK light goes OFF and the front left tire lowers to the ground
consistently during steps 4 through 7, the Stabil-TRAK system is not
functioning properly and the test should be stopped immediately. Contact
your local Sky Trak Distributor immediately to repair the system.
Stabil-TRAK System Test
WARNING:
DO NOT operate this vehicle unless you are in
the seat with the seat belt fastened around you. Serious injury or
death could result if the belt is not securely fastened