SkyTrak 10054 Operation Manual - Manual (Page 48)

Section 3 - Controls and Indicators
3-8 31200352
Transmission Control Lever
Direction of Travel Selection
Transmission control lever (1) engages forward or reverse travel.
• Push lever forward for forward travel; pull lever rearward for reverse travel. Move
lever to centered position for neutral.
• Forward or reverse travel can be selected while in any gear.
• When traveling in reverse, the back-up alarm will automatically sound.
• Drive in reverse and turn only at slow rates of speed.
• Do not increase engine speed with the transmission in forward or reverse and the
service brake depressed in an attempt to get quicker hydraulic performances.
This could cause unexpected machine movement.
• (6042, 8042, 10042 & 10054 Only) With lever in neutral and boom angles greater
than 40°, locked mode of Stabil-Trak system is activated. See page 3-16.
WARNING
TIP OVER/CRUSH HAZARD. Bring telehandler to a complete stop before
shifting transmission control lever. A sudden change in direction of travel could
reduce stability and/or cause load to shift or fall.
OH3831
F
N
R
1