SkyTrak 10054 Operation Manual - Manual (Page 149)

Section 8 - Additional Checks
8-1 31200352
SECTION 8 - ADDITIONAL CHECKS
8.1 STABIL-TRAK (6042, 8042, 10042 & 10054)
A. Stabil-Trak Indicator Test
Stabil-Trak system operates in three modes. In locked mode the indicator light
illuminates. If indicator does not illuminate the test was not performed properly or
Stabil-Trak system is not functioning correctly and the test should be stopped
immediately. To check the indicator, perform the following:
1. Test Stabil-Trak system on a level surface and boom fully retracted, no load.
2. Shift transmission to neutral (6).
3. Raise boom above 40° (2). Stabil-Trak system locked mode will be activated
and indicator (4) will illuminate.
4. Lower boom below 40° (1).
5. Depress service brake pedal (5) and shift transmission into forward.
6. Raise the boom above 40°. Stabil-Trak system locked mode will be activated
and indicator will illuminate.
7. Lower boom below 40°.
8. Engage park brake switch (3).
9. Release service brake pedal.
10. Raise the boom above 40°. Stabil-Trak system locked mode will be activated
and indicator will illuminate.
11. Lower boom below 40°.
12. Shift transmission to neutral.
10
OW0970 OH4340
OH4331
1
2
6
3
5
4