BNC 7000 Series Programmer Manual User Manual
Page 25
25
SENSe:FREQuency:AUTO
{ON|OFF|1|0}
ON
SENSe:FREQuency;DETect
{ALWays | ONCe | NEVer}
ALWays
SENSe:POWer
Hz
SENSe: POWer:EXECute
SENSe: POWer:AUTO
{ON|OFF|1|0}
ON
SENSe: POWer;DETect
{ALWays | ONCe | NEVer}
ALWays
SENSe :XX:AVERage
{1 ~ 99999}
1
SENSe:XX:ASET|ATTenuation
{1 ~ 30}
dB
SENSe:XX;ASET|ATTenuation:AUTO
{ON|OFF|1|0}
ON
SENSe:XX:ASET|ATTenuation:DETect
{ALWays | ONCe | NEVer}
ALWays
SENSe:XX:IFGain
rad / V
SENSe:XX:IFGain:AUTO
{ON|OFF|1|0}
ON
SENSe:XX:IFGain;DETect
{ALWays | ONCe | NEVer}
ALWays
SENSe:XX:FREQuency:STARt
{ 0.1 | 0.5 | 1 | 10 | 100 | 1k
| 10k | 100k }
Hz
SENSe:XX:FREQuency:STOP
{1k | 10k | 100k | 1M |10M
| 50M }
Hz
SENSe:XX:FREQuency:SPOT
{1 ~ 10M}
Hz
SENSe:XX:POINTs
{1 ~ 9999}
1
FW 1.0
SENSe:XX:PPD
{1 ~ 999}
1
SENSe:XX:SPURious:OMISsion
{ON|OFF|1|0}
FW 1.0
SENSe:XX:SPURious:TH
{ON|OFF|1|0}
FW 1.0
SENSe:XX:SPURious
{ON|OFF|1|0}
FW 1.0
SENSe:XX:SMOothing:APERture
{0.05 ~ 20}
%
FW 1.0
SENSe:XX:SMOothing:STATe
{ON|OFF|1|0}
FW 1.0
SENSe:RESet
FW 1.0
SENSe:MODE
Sets the active measurement mode. PN: phase noise, TRAN: transient measurement, BB: FFT
analyzer mode
SENSe:PN:METHod
Sets the active measurement configuration. This command affects PN measurement with external
references sources only.
SENSe:BB:METHod
Sets the active measurement configuration.
Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901
Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected], Web: www.berkeleynucleonics.com