4 :sense subsystem – BNC 7000 Series Programmer Manual User Manual
Page 24
24
The :INITiate subsystem controls the state of the SERIES 7000 trigger system. The subsystem
commands and parameters are described below. The :INITiate commands, along with the :ABORt and
:TRIGger commands, comprise the Trigger Group of commands.
Command
Parameters
Unit
(default)
Remark
:INITiate[:IMMediate]
ON
:INITiate:CONTinuous
{ON|OFF|1|0}
OFF
:INITiate[:IMMediate]
Sets SERIES 7000 trigger to the armed state.
:INITiate:CONTinuous ON|OFF|1|0
Continuously rearms the SERIES 7000 trigger system after completion of a triggered
sweep.
5.4 :SENSe Subsystem
The SENSe command subsystem directly affects device- specific settings used to make
measurements. The SENSe subsystem is optional since this is the primary function of the instrument.
Command
Parameters
Unit
(default)
Remark
SENSe:BB:METHod
{SINGle | CC}
CC
SENSe:MODe
{PN | TRAN | BB}
PN
SENSe:PN:INTegrate:START
Hz
SENSe:PN:INTegrate:STOP
Hz
SENSe:PN:KPHI
rad / V
SENSe: PN:KPHI:AUTO
{ON|OFF|1|0}
ON
SENSe: PN:KPHI;DETect
{ALWays | ONCe | NEVer}
ALWays
SENSe:PN:METHod
{SINGle | DUT | CC}
CC
:SENSe:PN:LOBandwidth
{0.1 ~ 10k}
Hz
:SENSe:PN:LOBandwidth:AUTO
{ON|OFF|1|0}
ON
:SENSe:PN:REFerences
{INT | EXT}
INT
:SENSe:PN:REFerences:SENS
Hz / V
:SENSe:PN:REFerences:SENS:EXECute
SENSe:FREQuency
Hz
SENSe:FREQuency:EXECute
Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901
Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected], Web: www.berkeleynucleonics.com