BNC 7000 Series Programmer Manual - Manual (Page 14)

14
*RST. However, cycling the instrument power will reset it to zero.
3.1.10 *SRE?
The Service Request Enable (SRE) query returns the value of the Service Request Enable Register.
Range 0–63 & 128-191
3.1.11 *STB?
The Read Status Byte (STB) query returns the value of the status byte including the master summary
status (MSS) bit.
Range 0–255
3.1.12 *TRG
The Trigger (TRG) command triggers the device if LAN is the selected trigger source, otherwise, *TRG
is ignored.
3.1.13 *TST?
The Self-Test (TST) query initiates the internal self- test and returns one of the following results:
0 This shows that all tests passed.
1 This shows that one or more tests failed.
3.1.14 *WAI
The Wait- to- Continue (WAI) command causes the instrument to wait until all pending commands are
completed, before executing any other commands.
Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901
Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected], Web: www.berkeleynucleonics.com