BNC 7000 Series Programmer Manual - Manual (Page 22)

22
5 SCPI Command Description
5.1 :ABORt Subsystem
The :ABORt command is a single command subsystem. There are no subcommands or associated
data parameters, as shown below. The :ABORt command, along with the :TRIGger and :INITiate
commands, comprise the Trigger group of commands.
Command Parameters Unit
(default)
Remark
:ABORt FW 1.0
:ABORt
This command causes measurement or sweep in progress to abort. Even if INIT:CONT[:ALL] is set to
ON, the sweep will not immediately re-initiate.
5.2 :CALCulate Subsystem
The CALCulate subsystem performs post acquisition data processing. Functions in the SENSe
subsystem are related to data acquisition, while the CALCulate subsystem operates on the data
acquired by a SENSe function.
The subsystem works for BB (baseband noise), and PN (phase noise), respectively.
Command Parameters Unit
(default)
Remark
:CALCulate:PN:TRACe:HOLD {OFF|MAX|MI
N}
OFF
:CALCulate:FREQuency? Hz
:CALCulate:POWer? dBm
:CALCulate:XX:SPOT? dBc/Hz FW 1.0
:CALCulate:PN:TRACe:FREQuency? Hz
:CALCulate:PN:TRACe:SPECtrum? dBc/Hz
:CALCulate:BB:TRACe:NOIse? dBV/Hz FW 1.0
:CALCulate:PN:TRACe:SPURious:FREQuency? FW 1.0
:CALCulate:PN:TRACe:SPURious:POWer? dBc FW 1.0
:CALCulate:PN:TRACe:FUNCtion:AVARiance? FW 1.0
:CALCulate:PN:INTegral? FW 1.0
:CALCulate:PN:JITter? FW 1.0
Berkeley Nucleonics Corporation 2955 Kerner Blvd., San Rafael, CA 94901
Phone: 415-453-9955, Fax: 415-453-9956, Email: [email protected], Web: www.berkeleynucleonics.com