OR-Fab 87034 JK WRANGLER HD TRANSMISSION CROSS MEMBER - Manual (Page 3)

3 JK HD Transmission Cross Member - Kit 87034
h. Using a pry bar on drivers side of cross member;
gently free cross member from frame mount
until cross member is free from transmission
mounting studs & frame mounts.
Prepare to Install Kit
1. Install Kit HD Cross Member.
a. Using four factory 12mm bolts & nut, install kit
HD cross member into frame mounts and
transmission mounting studs. (Note: Be sure to
install kit HD cross member with notched end
at drivers side frame mount.)
Frame Mount Cross Member
Kit HD Cross
Member Indication Notch
b. Using a 16mm socket, reinstall three factory
transmission mounting nuts into center of kit HD
cross member.
c. Using a 18mm socket, support and reinstall two
factory 12mm bolts into transmission skid plate
at frame mounts. Use one kit 1/2” button head
bolt & washer to mount transmission skid plate
to kit HD cross member.
d. Continue by installing two kit 1/2” button head
bolt & washer through the gas tank skid plate
and into kit HD cross member.
e. Using a 18mm socket, support and reinstall two
factory 12mm bolts through transfer case skid
plate at frame and gas tank skid mounts. Use
two kit 1/2” button head bolt & washer to
mount transmission skid plate to kit HD cross
member.
Transmission
Mount
Kit HD Cross Member
Transmission
Skid Plate
Transfer Case
Skid Plate Gas Tank
Skid Plate
Install Five Kit 1/2” button
head bolt & washer