OR-Fab 87035 TIRE CARRIER T-HANDLE LICENSE PLATE RELOCATION BRACKET - Manual (Page 2)

‘87-UP JK, TJ & YJ T-Handle License Plate Relocation 2 Kit #87035
Install Relocation Bracket
1. Install kit license plate reloctaion bracket
a. Install kit bracket into carrier T-Handle using 3/
8” studs.
b. Using kit two 3/8” washers, lock washers &
wing nuts; secure kit bracket to T-Handle. .
c. Install license plate using four kit 1/4” button
head bolts, washers and flange nuts. .
After Completing Installation
Miscellaneous
1. Check all fasteners to ensure they are tight.
2. Ensure all wires, hoses, cables, etc. are properly
connected and there is ample slack.
WARNING
This product is for Off-Road use only. Always make
sure all occupants are wearing seat belts at all times.
Kit Bracket
Kit 3/8”
Hardware
Kit Bracket
Kit 1/4”
Hardware
Kit Parts List
Qty. Description
1 Bracket, License Plate
1 (Hardware bag)
2 Bolt (3/8” Wing Nut)
2 Washer (3/8” USS)
2 Washer (3/8” Lock Washer)
4 Bolt (1/4” Button Head)
4 Washers (1/4” SAE)
4 Nut (1/4” Flange Nut)
NOTE
All warranty information, instruction sheets, and other
documents regarding the installation of this product
must be retained by the vehicle owner. Information
contained in the instructions and on the warranty card
will be required for any warranty claims. The vehicle
owner needs to understand the modifications made to
the vehicle and how they affect vehicle handling and
performance. Failure to provide the customer with this
information can result in damage to the vehicle and
severe personal injury.