OR-Fab 83218 JK REAR PLATE METAL BUMPER W/ LED BACKUP LIGHTS - Manual (Page 4)

4 Rock Slider Rear Bumper w/LED Lamps - Kit 83218
a. Position Kit Nut Plate inside both pass and drvr
frame rail so that nuts line up with holes as
shown.
b. Position kit bumper on vehicle. Secure bumper
to frame rail on both sides using kit, 10m-1.5x40
bolts & washers, for forward two holes and kit
1/2” x 1-1/2” bolts & 1/2” washers through nut
plate inside frame rail. Do not tighten at this
time.
OE Frame Rail
Nut Plate
Align Nut
Plate with
frame holes
1/2” x 1-1/2” bolts &
washers 10m -1.5x40 bolts
& washers
c. Install two kit bolts (3/8-16x1) through bumper
center plate and into kit anchor bracket..
d. Insure bumper is centered and level. Tighten
down all hardware at this time.
4. Install Kit LED Backup Lights
a. Use kit LED grommet and press grommet into
cutout of bumper. Pull each kit plug through
grommet.
b. Plug wire harness into kit LED backup light and
gently install light into kit LED grommet. (Note:
Soap and water mixture will help light slide into
place properly without damaging backup light.
Allow soap and water to dry before making final
light adjustments).
Bumper
Anchor Bolts
Plug Light Harness
Rubber LED
Grommet
LED Backup Lights