OR-Fab 83100 ROCK SLIDER REAR BUMPER CJ / TJ / TJL - Manual (Page 2)

2 Jeep Rock Slider Rear Bumper - Kit 83100
2. Kit bumper
a. Install kit bumper on frame with four kit bolts
(3/8” x 1”), kit washers (3/8” USS), and kit nuts
(3/8” serrated flange) at outer holes.
b. 1987-97 vehicles: In the remaining holes,
secure kit bumper to frame crossplate with four
kit bolts (3/8” x 1” self-tapping flange-head), kit
washers (3/8” USS), and kit nuts (3/8” serrated
flange).
c. 1998 and later vehicles: Using any of the
remaining holes in kit bumper as a template,
drill four 5/16” holes in frame crossplate. Secure
kit bumper to frame crossplate with four kit
bolts (3/8” x 1” self-tapping flange-head) in
drilled holes.
d. Fasten tow hooks (if equipped) and kit bumper
to bottom of frame using stock bolts.
Accessories
The following accessories are also available:
Kit # 83095: Rock Slider Front Bumper (YJ)
Kit # 83096: Rock Slider Front Bumper
w/ Grille Guard (YJ)
Kit # 83200: Rock Slider Front Bumper (TJ)
Kit # 83201: Rock Slider Front Bumper
w/ Grille Guard (TJ)
Kit # 84095: Rock Slider Side Bars (YJ)
Kit # 84100: Rock Slider Side Bars (TJ)
Kit # 84200: Rock Slider Rocker Panels (TJ)
Parts list
Qty. Description
4 Bolt, 3/8” x 1”
4 Bolt, 3/8” x 1” self-tapping flange-head
1 Bumper
8 Nut, 3/8” serrated flange
4 Washer, 3/8” USS
Kit Bolt (3/8” x 1”),
Washer (3/8” USS),
Nut (3/8” Serrated Flange)
1987-97 Vehicles
Kit Bolt (3/8” x 1” Self-Tapping Flange-Head),
Washer (3/8” USS),
Nut (3/8” Serrated Flange)
Drill 5/16” Holes, Then Install Kit Bolt
(3/8” x 1” Self-Tapping Flange-Head)
1998 and Later Vehicles
Rev. 01, Copyright 07/06
Performance Automotive Group
www.p-a-g.net