OR-Fab 83201 JEEP TJ-TJL ROCK SLIDER FRONT BUMPER W/GRILL GUARD (97-05 TJ & 04-05 TJL) - Manual (Page 2)

2 Jeep - Kits 83095, 83096, 83200, 83201
Install kit
1. Stock front bumper.
a. Remove four torx bolts and tow hooks.
b. Remove two torx bolts from underside of
bumper.
c. Remove stock bumper from vehicle.
2. Winch. (Skip this step if not installing a winch)
a. Set winch plate and winch in place.
b. While lifting front of winch plate, set kit bumper
on frame under winch plate.
3. Front kit bumper.
a. Install kit bumper on frame using original fasten-
ers.
b. If not installing the optional Multi-Light Mount
(87011) on the kit bumper, plug the holes with
the kit plastic caps.
Accessories
The following accessory is also available:
Kit # 87011: Multi-Light Mount
Kit Parts List
Qty. Description
1 Bumper, front
4 Cap, plastic
Rev. 01, Copyright 08/04 Performance Automotive
Group
NOTE
It is not possible to install winch with kit bumper
installed.
NOTE
If kit bumper mounting tabs fit tightly over frame, bend
tabs with an adjustable wrench.
Winch
Kit Bumper
Mounting Tab
Winch
Plate
Frame
NOTE
Four holes on the front of the kit bumper will accom-
modate a Hi-Lift jack, a Multi-Light Mount, or both.
Multi-Light Mount (Kit # 87011)