OR-Fab 87041 00-06 TOYOTA TUNDRA / 01-07 SEQUOIA TRANS. SKID PLATE/CAT THEFT SHIELD - Manual (Page 2)

Toyota Transmission Skid & Cat Theft Deterrent 2 Kit #87041
Install Skid Plate
1. Install kit skid plate
a. Install front of kit skid plate using two kit bolts
(M8-1.25x25) & washers into rear control arm
cross member existing holes.
b. Using two kit 3/8” washers, spacers & bolts to
secure kit skid plate onto transmission cross
member.
c. Be sure all of your edges are lined up and clear
any brake lines or fuel lines. Tighten all kit
hardware at this time.
Rear Control Arm
Cross Member
Kit Bolts (M8)
Kit Skid Plate
Kit 3/8”
Hardware &
Spacer
Kit Spacer
Transmission
Cross Member
Kit Skid Plate Installed
After Completing Installation
Miscellaneous
1. Check all fasteners to ensure they are tight.
2. Ensure all wires, hoses, cables, etc. are properly
connected and there is ample slack.
Kit Parts List
Qty. Description
1 Bracket, Skid Plate
1 (Hardware bag)
2 Bolt (3/8” Button Head)
2 Washer (3/8”)
2 Spacer (3/4”x1/4”)
2 Nut Plate (3/8”)
2 Bolt (M8 Button Head)
2 Washers (M8)
WARNING
This product is for Off-Road use only. Always make
sure all occupants are wearing seat belts at all times.
NOTE
All warranty information, instruction sheets, and other
documents regarding the installation of this product
must be retained by the vehicle owner. Information
contained in the instructions and on the warranty card
will be required for any warranty claims. The vehicle
owner needs to understand the modifications made to
the vehicle and how they affect vehicle handling and
performance. Failure to provide the customer with this
information can result in damage to the vehicle and
severe personal injury.