Class1 EZFill Foam Refill - Manual (Page 5)

Safety Precautions ❑
5 EZFill Installer / User Guide, p/n: 029-0020-82-0
1 Safety Precautions
IMPORTANT !
THE CLASS 1 “EZFILL
TM
” FOAM TANK REFILL SYSTEM IS DESIGNED FOR OPTI-
MUM SAFETY OF ITS OPERATORS. FOR ADDED PROTECTION AND BEFORE
ATTEMPTING INSTALLATION OR OPERATION PLEASE FOLLOW THE SAFETY
GUIDELINES LISTED IN THIS SECTION AND ADHERE TO ALL WARNING, DAN-
GER, CAUTION AND IMPORTANT NOTES FOUND WITHIN THIS GUIDE.
THIS SECTION ON SAFETY MUST BE CAREFULLY READ, UNDERSTOOD AND
ADHERED TO STRICTLY BY ALL INSTALLERS AND OPERATORS BEFORE
ATTEMPTING TO INSTALL OR OPERATE THE EZFILL FOAM REFILL SYSTEM.
WHEN DEVELOPING DEPARTMENTAL APPARATUS OPERATING PROCE-
DURES, INCORPORATE THE WARNINGS AND CAUTIONS AS WRITTEN.
EZFill is a trademark of Class1. All other brand and product names are the trade-
marks of their respective holders.
1.1 GUIDELINES
READ ALL INSTRUCTIONS THOROUGHLY BEFORE BEGINNING
ANY INSTALLATION OR OPERATION PROCESS.
❑ Installation should be performed by a trained and qualified installer, or
your authorized Class1 service representative. Be sure the installer has
sufficient knowledge, experience and the proper tools before attempting
any installation.
❑ The installer is responsible for observing all instructions and safety pre-
cautions in his or her daily routine as dictated by regional safety ordi-
nances or departmental procedures.
❑ DO NOT permanently remove or alter any guarding or insulating devices,
or attempt to operate the system with these guards removed.
Make sure all access/service panels and covers are installed, closed and
latched tight, where applicable.
❑ DO NOT remove or alter any hydraulic or pneumatic connections, electri-
cal devices, etc. DO NOT tamper with or disconnect safety features or
modify protective guards (such as covers, or doors). DO NOT add or
remove structural parts.