Belkin F5D8235-4 - Manual (Page 48)

46
N+ Wireless Router
sections
table of contents 1 2 3 4 5 7 8 9 10 6
UsINg THe Web-based adVaNCed UseR INTeRfaCe
Using the access Point Mode
Note: This advanced feature should be employed by advanced users
only . The Router can be configured to work as a wireless network
access point . Using this mode will defeat the NAT IP sharing feature and
DHCP server . In AP mode, the Router will need to be configured with an
IP address that is in the same subnet as the rest of the network that you
will bridge to . The default IP address is 192 .168 .2 .254 and subnet mask
is 255 .255 .255 .0 . These can be customized for your need .
1� Enable the AP mode my selecting “Enable” in the “Use as Access
Point only” page . When you select this option, you will be able to
change the IP settings .
2� Set your IP settings to match your network . Click “Apply Changes” .
3� Connect a cable from the WAN port on the Router to your existing
network .
The Router is now acting as an access point . To access the Router
advanced user interface again, type the IP address you specified into
your browser’s navigation bar . You can set the encryption settings, MAC
address filtering, SSID, and channel normally .