Brother HL 2700CN - Manual (Page 125)

5 - 20 ROUTINE MAINTENANCE
Figure 5-27
5) Put in the new transfer roller by holding the lock levers of the transfer roller and adjusting the
angle of the transfer roller lever shafts (both sides) to match the transfer unit grooves. Put the
transfer roller onto the shafts and place the roller onto the springs as shown below:
Figure 5-28
6) Push the lock levers down to lock the transfer roller into place.
7) Close the back cover.
8) Turn the printer power switch back on.
Figure 5-29 Figure 5-30
Lock levers
Transfer roller shaft
Spring