2 replacing batteries or rechargeable power packs – Philips DVT5500-00 User Manual
Page 54
54
Service
Tip
• Press the j key to cancel the operation without saving and return
to the stop mode.
10.2 Replacing batteries or rechargeable power
packs
Caution
• Do not remove batteries or rechargeable batteries from the
device while it is recording. If you do this, data may be damaged or
lost. Device malfunctions may also occur.
When the batteries are nearly empty, the battery indicator blinks;
you should replace them. The number of the rechargeable power
pack charge cycles is also limited. If the rechargeable batteries do not
provide any power after a complete charging cycle via the computer,
they must be replaced.
Proceed as described in
Note
• If it takes longer than 2 minutes to replace the batteries, you may
have to reset the time.
• Never try to recharge alkaline or non-rechargeable batteries.
• Batteries and rechargeable batteries contain substances that
may pollute the environment. Used batteries and rechargeable
batteries should be disposed of at an official collection point.
10.3 Replacing the remote control battery
(DVT5500, DVT7000)
Note
• Follow the instructions on handling the device, especially the
batteries shown in
1 Important safety information
. Only use
CR2025 type batteries for the remote control.
1
Remove the battery cover from the remote control by opening
the latch of the battery compartment on the back of the remote
control and take out the battery compartment.