Philips Kaffeevollautomat User Manual

Page 11

Press the ^ or % button to select the desired coffee strength.

Press OK when the display shows the desired coffee strength.

Place 1 cup under the coffee spout to make 1 cup of coffee or cups

to make cups of coffee.

For creamier coffee, pull the spout downwards to bring it as close to the

cups as possible.
Tip: To keep the coffee hot longer, preheat the cups you use. Especially heat

up thick cups, as they absorb a lot of heat. To preheat the cups, put them on

the cup warmer tray when the appliance is switched on or rinse them with hot

water before use.

Press the button for short coffee, for standard coffee or for long

coffee.

Press the button once for 1 cup or twice within 2 seconds for 2 cups.

You can interrupt the brewing process at any time by pressing the

button for short coffee, for standard coffee or for long coffee, as

previously selected.

If the coffee comes out one drop at a time, not at all or too fast, adjust

the grinding coarseness (see section ‘Adjusting the coffee mill’).

You can also change the standard amount of coffee the appliance

brews, see section ‘Changing the coffee quantity for espresso’ below.

The appliance grinds the beans and brews coffee.

Once the set amount of coffee has been brewed, the appliance

automatically stops brewing and ejects the coffee grounds into the

waste bin.

After a few seconds, ‘READY TO USE’ appears on the display to

indicate that you can brew the next cup of coffee.

If the message ‘EMPTY WASTE BIN!’ appears, remove the waste

bin and empty and clean it.

Note: The message ‘EMPTY WASTE BIN!’ appears after every 14 cups. When

it appears, you cannot brew coffee again until you empty and clean the waste

bin.

1 Open the service door at the front by pulling the latch.

EnglisH