Blount ICS 613GC - Manual (Page 67)

F/N 71537 Oct 07 © 2007 ICS, Blount Inc.
TITLE 613GC SERVICE MANUAL
65
21. BAR STUDS & BAR PAD
21 This section covers the removal
and installation of the bar studs
and bar pad.
NOTE: On saws with Serial #’s
beginning 0482421700 and
071XXXXXXX, it is necessary to
remove the bar mount pad cover
plate first.
21.1 Remove bar studs.
A Remove side cover.
B Install side cover nuts, flange to
flange and tighten together.
C Attempt to remove the inside nut
which should pull out the bar stud.
D Repeat on second bar stud.
21.2 Remove bar pad.
A Remove sealing o-ring.
21.3 Assemble in reverse order.