Shop manual use – Blount ICS 613GC User Manual

Page 4

F/N 71537 Oct 07

TITLE

613GC SERVICE MANUAL

SHOP MANUAL USE

Shop Manual Use

This manual contains all the technical information necessary for carrying out repairs on the
613GC cut-off saw. For safe, efficient work, it is of prime importance that the values indicated
be adhered to. Routine periodic maintenance is covered in the operator’s manual included with
each cut-off saw.

General Shop Rules

• Always use the right tools for the job, otherwise components may be damaged.

• Use a plastic dead blow mallet to separate parts attached solidly to each other.

• Mark mating parts as a reassembly reference.

• Keep component parts together as a group. Assemble screws and nuts into appropriate

subgroups.

• When reassembling, clean all parts carefully, lubricate moving parts and replace all oil seals,

orings, gaskets, washers and self-locking nuts.

• For best results, use only original ICS

replacement parts.

General Recommendations

• Some procedures in this manual require the use of special tools. A complete tool kit for ICS

cut-off saws is available from ICS

• Detailed carburetor maintenance and overhaul information is available in Walbro’s

Diaphragm Carburetor Service Manual. Walbro can be contacted at http:\\www.walbro.com
or by calling 1.989.872.2131.