Two l-shaped mounting brackets, Figure 10 4-post screws and retainer nuts, Figure 10 – Brocade Communications Systems Brocade ICX 6650 53-1002599-01 User Manual
Page 31

Brocade ICX 6650 Hardware Installation Guide
15
53-1002599-01
Installing the device in a rack or cabinet
2
Remove the rack mount kit from the shipping carton. The kit contains the following:
•
Two L-shaped mounting brackets.
•
Four rack mount rails: two for side attach and two for rear attach racks.
•
Thirty-two 8-32 x 5/16 in., panhead Phillips screws with patchlocks.
•
Eight 10-32 x 5/8 in., panhead Phillips screws (torque to 25 in-lb, 29 cm-kg). See item 1 in
.
•
Eight 32-10 retainer nuts (for square-hole rack rails). See item 2 in
•
Eight 32-10 retainer nuts (for round-hole rack rails) See item 3 in
FIGURE 10
4-post screws and retainer nuts
Use the following steps to mount devices in a 4-post rack.
CAUTION
Do not use the hardware supplied in a 2-post rack mounting kit to mount a Brocade ICX 6650
device in a 4-post rack. Mounting the device in a 4-post rack requires additional hardware to
prevent drooping from possible flexing and distortion of the 4-post rack when a device is not
properly installed.
1. Attach the mounting brackets to the sides of the device as illustrated in
above using
the 8-32 x 5/16 in. screws.
2. Attach the appropriate rails: either side attach or rear attach at determined by the type of rack
in which you are installing the device.
show exploded views of the optional 4-post rack mount kit.
1
2
3