Brocade Communications Systems Brocade ICX 6650 53-1002599-01 - Manual (Page 29)

Brocade ICX 6650 Hardware Installation Guide 13
53-1002599-01
Installing the device in a rack or cabinet
2
2-Post rack mount installation
NOTE
Use the following procedure when installing the Brocade ICX 6650 device in a 2-post rack. For 4-post
racks, follow the procedures in the section
“4-Post rack mount installation” on page 14.
Remove the rack mount kit from the shipping carton. The kit contains the following:
• Two L-shaped mounting brackets.
• Sixteen 8-32 x 5/16 in., panhead Phillips screws with patchlocks.
• Four 10-32 x 5/8 in., panhead Phillips screws (torque to 25 in-lb, 29 cm-kg). See item 1 in
Figure 7 .
• Eight 32-10 retainer nuts (for square-hole rack rails). See item 2 in Figure 7 .
• Eight 32-10 retainer nuts (for round-hole rack rails) See item 3 in Figure 7 .
FIGURE 7 2-post screws and retainer nuts
Use the following steps to mount devices in a 2-post rack.
1. Attach the mounting brackets to the sides of the device as illustrated in Figure 8 using the
8-32 x 5/16 in. screws.
FIGURE 8 Attaching the brackets for Brocade ICX 6650 devices
1 2 3