Bosch D1260 - Manual (Page 74)

D1260/D1260B | Owner's Manual | Part IV: Multi-Area Use - Turning Off the System
74 Bosch Security Systems | 9/04 | 50410D
2. Press the Menu> key to enter the Command
Menu.
3. Press the Next> soft key repeatedly until you
reach the DISARM ?> prompt then press the
adjacent soft key.
4. If entering through a door which is part of an area
that is armed, the display changes to show:
5. Enter your passcode and press ENTER.
The passcode is shown as asterisks (*) when
entered and advance from the right side of the
display to the left until all the passcode digits are
entered.
6. If the entered passcode is valid, the display
changes to show DISARM ALL?
Press the Disarm> soft key to disarm all armed
areas.
Press the
Next> soft key to go to the first armed
area (see Turning Off Selected Areas).
Press the
soft key to go to the last
armed area.
Press the
soft key to return to idle text.
7. If the Disarm> soft key is pressed to disarm all
areas, the display changes to show Disarm:
12345678 All user-authorized areas are now
disarmed.
indicating that all areas are being
turned off. Command center scope and/or your
authority level limit the actual number of areas you
may turn off.
For example, if you have authority to disarm all 8
areas but the scope of the command center you’re
using is limited to areas 1, 2, and 5, then you will
only be able to turn off areas 1, 2, and 5.
Turning Off Selected Areas
If your passcode has the proper authority level this
function allows you to turn off areas other than the one
you are in.
1. The display initially shows that the system is
armed.
2. Press the Menu> key to enter the Command
Menu.
3. Press the Next> soft key repeatedly until you
reach the DISARM ?> prompt then press the
adjacent soft key.
4. If entering through a door which is part of an area
that is armed, the display changes to show: