Bosch D1260 - Manual (Page 14)

D1260/D1260B | Owner's Manual | Part I: Security system basics - Silencing an Alarm
14 Bosch Security Systems | 9/04 | 50410D
Entry Delay Tone and Display
When you enter an armed system through a point
programmed for entry delay, the keypad emits a
repeating warble tone and displays the following to
remind you to turn off your security system.
If you fail to turn off the security system before the
entry delay time expires, it may sound the burglary
tone and may also send an alarm report to your
security company.
Exit Delay Tone and Display
After you arm your system, the keypad emits a
repeating beep tone, displays
AREA 1 NAME TEXT
is now arming… then
EXIT NOW! and counts down the exit delay time.
Keystroke Checking Tones
Valid Entry
If you press an appropriate key for the function or
entry you desire, the keypad emits a muted beep tone,
indicating it accepted your keystroke.
Invalid Entry
A flat buzz tone sounds when you perform a function
that is not allowed or when the keypad has no
information to display.
Silencing an Alarm
The audible alarm sounds for a specific period of time
before it automatically shuts off. If an alarm occurs and
you want to silence the siren before the time expires,
simply enter your personal passcode and press
ENTER.
To SILENCE an alarm:
Enter your passcode and press ENTER.
How Your System Reports Alarms
Your security system may be programmed to
automatically disconnect your telephones when
sending reports to your security company. Once the
report is completed, your security system returns the
telephones to normal operation (check with your
security company). Other methods of communicating
alarm conditions are also available. Please consult your
security company for services available in your area.
Your system makes repeated attempts to send reports
to your security company.
In the event your security system fails to communicate,
the keypad sounds a Trouble Tone and displays
AREA
1 WAREHOUSE Comm Fail Route Grp1 (where the
Route Group can be 1, 2, 3, or 4):
Notify your security company of the communications
failure.
If your system uses telephone lines as its
means of communication and telephone
service is interrupted, your security
system cannot send reports to your
security company unless it has an
alternate means of transmitting them.