Bosch D1260 - Manual (Page 20)

D1260/D1260B | Owner's Manual | Part II: System Commands - MASTER ARM ? (COMMAND + 1)
20 Bosch Security Systems | 9/04 | 50410D
Master Arming all Areas
If you prefer, you may use the Master Arm ?>
command in the Command Menu to initiate this
function which will arm all available areas according to
your authority level.
1. The display shows disarmed idle text.
2. Press the MENU> soft key to enter the Command
Menu,
3. then press NEXT> soft key repeatedly
4. until you reach the MASTER ARM ?> prompt.
Press the soft key.
5. The display may prompt you to enter your
passcode.
The passcode is shown as asterisks (*) when
entered.
6. If there is more than one area that is set up, the
option is given to arm all of them with
MASTER
ARM ALL ?
or by pressing the Next> soft key…
to view each unarmed area and optionally arm
each one.
7. To arm a selected area, press Next> until the
desired area appears (Area name text along with
Arm Area # ?).
8. Then press Arm>
9. The next available area will appear with the option
to arm it.
Every time the Next> , or Arm> soft
keys are pressed, the display scrolls to the next
unarmed area.
10. To arm all available areas, press the Arm> soft
key when the display reads Master Arm All ?
11. The display changes to show that all areas are
arming.
Depending on what areas are armed or areas that
you have authority,
12345678 may or may not
appear.
12. then displays Exit now # (# = exit delay time
remaining).
After the exit delay time expires, the display
changes to idle armed text.