Bosch D1260 - Manual (Page 55)

D1260/D1260B | Owner's Manual | Part III: Advanced Commands - ADD/CHANGE USER (COMMAND + 5 + 6)
Bosch Security Systems | 9/04 | 50410D 55
3. The display changes to Enter new passcode:
Enter the new passcode.
As soon as a number is pressed,
Entering: appears
on the third line next to the asterisks.
The passcode is shown as asterisks (*) when
entered and advance from the right side of the
display to the left until all passcode digits are
entered.
Press the
ENTER button.
If the passcode matches the previously enter
passcode, the display changes to Passcode added.
Pressing the
Next> soft key advances to the
Add/Change Level (if the panel is a D9112 or
D7212) or Add/Change Card (if the panel is a
D9412 or D7412).
If an invalid passcode is entered, the command
center will momentarily display
Passcode is
already in use. Please try again.
If the passcode does not match, the command
center will emit an error tone and display
Passcode not changed.
Pressing the Next> soft key advances to the
Add/Change Level (if the panel is a D9112 or
D7212) or Add/Change Card (if the panel is a
D9412 or D7412).
4. The display changes to User 123 Change this
user’s passcode?
Press the Yes> soft key to change the passcode.
Press the No> soft key not to change the passcode
and skip ahead to Add/Change Level (if the
panel type is a D9112 or D7212) otherwise if the
panel is a D9412 or D7412, the
Add/Change
Card appears next.
You will prompted for the user’s passcode.
As soon as a number is pressed,
Entering: appears
on the third line next to the asterisks.
It will appear on the display as asterisks (*).
Press the ENTER button.
The display changes to Enter new passcode again:
Enter the new passcode again.
Press the
ENTER button.
If an invalid passcode is entered, the command
center will momentarily display
Passcode is
already in use. Please try again.
If the passcode matches the previously enter
passcode, the display changes to
Passcode
changed.