Bosch D1260 - Manual (Page 54)

D1260/D1260B | Owner's Manual | Part III: Advanced Commands - ADD/CHANGE USER (COMMAND + 5 + 6)
54 Bosch Security Systems | 9/04 | 50410D
5. Enter the user number and press either the Enter>
soft key or the ENTER button.
6. The display changes to show the user number
entered and the user’s name (if any).
(User 2 is used as an example.)
Press the
Continue> soft key to proceed on to
changing the user’s information.
If there is no name for the user, the text USER 2
appears in the second line.
(User 2 is used as an example.)
Press the
Continue> soft key to change the user’s
information.
7. The display changes to Add/Change Menu.
The display varies depending on the type of
control panel that was installed in your system.
My system has a D9412 or D7412 Control
Panel
My system has a D9112 or D7212 Control
Panel
If your system has a D9412 or D7412 Control
Panel, this menu allows the following User items to
be changed:
• Passcode - Press the soft key to
change the user’s passcode.
•
Level - Press the soft key to change
the user’s Authority Level.
•
Name - Press the Name> soft key to change
the user’s name.
•
Card - Press the Card> soft key to change the
user’s card.
•
Sub-User - Press the Sub-User> soft key to
change the user’s sub-user status.
If your system has a D9112 or D7212 Control
Panel, this menu allows the following User items to
be changed:
•
Name - Press the Name> soft key to change
the user’s name.
• Passcode - Press the soft key to
change the user’s passcode.
•
Level - Press the soft key to change
the user’s Authority Level.
Add/Change Passcode
1. Pressing the or the Passcode> soft key
will allow you to add/change a user’s passcode.
User 123 is used here as an example.
2. The display changes to User 123 Add a passcode
for this user?
Press the Yes> soft key to add a new passcode.
Go to Step 3.
Pressing the No> soft key advances to
Add/Change Level, if the panel is a D9112 or
D7212, or Add/Change Card, if the panel is a
D9412 or D7412.
If the user already has an assigned passcode. it will
be detected by the panel and will automatically go
to Step 4.