Bunn G9-2T DBC - Manual (Page 28)

28
SERVICE (Cont.)
SNUBBER (Models G9, G9-2, MHG)
CO ARSE
FI
NE
TH OR OUG HLY CLEA N G RIND C HA MB ER B E F O R E R E A S S E M B LY
EM PTY H OPPER BE FORE RE MO VI N G T H IS C O V E R .
N OTIC E
CO ARSE
FI
NE
P611 GRN to Chasis Ground
YEL to Snubber
P621
WHI/ BLU to Snubber
WHI/BLU to Relay
WHI/BLK to Snubber
WHI/BLK to Cordset
(120V models)
RED/BLK to Cordset
(230V models)
FRANKLIN MOTOR
MARATHON MOTOR
GRN to Chasis Ground
YEL to Snubber
WHI/ BLU to Snubber
WHI/BLK to Snubber
WHI/BLU to Relay
WHI/BLK to Cordset
Location:
The snubber is located at the back of the motor
attached to the right side of the wiring harness.
Removal and Replacement:
1. Remove snubber wires from the motor terminals.
2. Cut the ties holding snubber to the wiring har-
ness.
3. Refer to the following illustration when reconnect-
ing the wires.
4. Fasten snubber to the wiring harness using new
ties.
FIG. 18 SNUBBER
FIG. 19 SNUBBER
41545 122209