Brother 580C - Manual (Page 115)

111
This mode allows you to quickly and easily make pre-inked stamps for any need.
After printing the stamp, affix the cut tape to a stamp holder for immediate and
frequent use. Since the stamp holder is reusable, just make a new stamp tape
and replace the one in the holder.
TO MAKE A STAMP:
(1) Type in your text, open the tape compartment cover insert a stamp cassette,
then close the cover.
(2) Hold down the CODE key and press the STAMP key. The message “STAMP
FORMAT” is displayed.
(3) Press the RETURN key to enter Stamp mode. The text is centered within the
preset message area and the tape length and margins are automatically adjusted.
(4) Press the RETURN key. Your text is cut from the installed stamp tape.
(5) Push down on the tape cutter lever, remove the backing paper from the stamp
tape and affix it to the ink pad of a stamp holder.
+
If stamp holder is being reused, peel off the old tape before affixing the
new one.