Buffalo Technology TeraStation HS-DTGL/R5 - Manual (Page 30)

0
Advanced Settings
Disk Management (RAID Configuration)
This page shows your current RAID arrays.
You.may.delete.old.arrays.or.create.new.ones.
by clicking on the underlined RAID Array #.
under.RAID Array Configuration...
You may also disable RAID Array Error Detection
Response from this page. Normally, this is set
to. automatically. shut. down. the. RAID. array.
when. an. error. is. detected.. . Though. it. is. not.
recommended, you may disable that behavior
by clicking Disable.and.then.Apply.under.RAID
Array Error Detection Response...
Note that your TeraStation has four internal hard drives. Before creating a new RAID array, you
may have to delete one or more pre-existing RAID Arrays to clear up the hard drives for your new
one. This will destroy all data currently on the disks, so back up any important data before deleting
RAID arrays. Whether you want to clear out an old array or create a new one, begin by clicking on
the.array’s.underlined.RAID Array #, under Name.