Neff B15P52N3GB - Manual (Page 26)

26
7. Do NOT unscrew the left and right-hand screws from the
sheet metal part (fig. E).
Clean the panels with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
Installation
During installation, make sure that the lettering "top right" is
upside down at the bottom left of both panels.
1. Insert the lower panel at an angle towards the back (fig. A).
2. Slide in the middle panel (fig. B).
3. Stick the retaining clips onto the right and left-hand side of
the panel, aligning them so that the retaining carriers are over
the screw holes, and then screw into place (fig. C).
4. Hook the seal in to the bottom of the panel again (fig. D).
5. Insert the uppermost panel at an angle to the back into the
brackets. Take care not to push the seal to the back (fig. E).
6. Insert the two small seals on the left and right of the panel
again (fig. F).
7. Put the cover back in place and screw it on.
8. Attach the oven door.
Do not use the oven again until the panels have been
correctly installed.
Faults and repairs
It is not always necessary to call the after-sales service.
Sometimes, you can find a remedy yourself. You will find some
tips for troubleshooting in the following table.
:
Risk of electric shock!
■
Work on the appliance electronics may only be performed by
a specialist.
■
Always disconnect the appliance from the power supply
when work is carried out on the electronics. Switch off the
circuit breaker or remove the fuse from your household fuse
box.
Malfunction table
(
% $
' &
) (
Problem Possible cause Note/remedy
Electrical operation is faulty (e.g. indicator
lamps no longer light up).
Circuit breaker faulty. Check fuses in the fuse box and replace if neces-
sary.
Liquid or thin batter runs to one side. Appliance not installed level. Check appliance installation (see the Installation
instructions).
Appliance no longer works, ‹ : ‹‹ flashes
in the clock display.
There was a power cut. Reset the time of day (see section: Electronic
clock).
‹ : ‹‹ flashes on the clock display,
“rrr”appears on the temperature display.
The power supply was inter-
rupted while the appliance was in
operation.
Press the clock function button, reset the time of
day (see section: Electronic clock).
The temperature display shows, EXXX,
e.g. “„‹‹ .
Internal fault in the appliance elec-
tronics.
Press the clock function button. If the message
does not go out, pull out the mains plug and plug it
back in again after approx. 10 seconds.