Sharp EL-9900 - Manual (Page 225)

215
Chapter 13: Programming Features
For variable, initial value, end value [, increment]
commands or multiple statements
Next
• The increment value can be omitted. The default value is 1.
• For and Next statements must be placed at the beginning of the
line.
• If the comparisons variable > end value (positive) or variable <
end value (negative) are satisfied, the program will end the loop
and go to the line indicated by the Next command.
• Up to 5 For loops can be nested, though if combined with other
types of loops, the maximum nested loop number may vary due
to the memory capacity.
• It is highly recommended that Label and Goto statements are
not used in For loop structures.
While conditional statements
commands or multiple statements
WEnd
• While and WEnd statements must be placed at the beginning of
the line.
• Multiple While loops can be nested to within the memory
capacity.
• Conditional statements are evaluated before entering the While
clause.
• It is highly recommended that Label and Goto statements are
not used in While loop structures.
* Up to 8 while loops can be nested, though if combined with
other types of loops, the maximum nested loop number may
vary due to the memory capacity.
Note: Else clause cannot be omitted when the matching If clause is
contained in a For or a While loop.
07 For
08 Next
09 While
10 WEnd
202_221_chapter13_en 02.8.23, 2:22 PM 215