Sharp ER-A280F - Manual (Page 116)

114
Press the key on the keyboard.
In the case of selecting “DIRECT PLU”
• TYPE (Use the selective entry)
PLU: Assigns the key as a direct PLU key.
DEPT: Assigns the key as a direct department key.
INHIBIT: Non-use
• You can also select a direct PLU key by pressing the
corresponding key when the PLU has been assigned directly on
the keyboard instead of selecting the key from the menu.
• When selecting a department, the screen on which a department
code is to be entered (the message “DEPT. CODE”) will appear.
• LEVEL1 through 3 (Use the numeric entry)
Enter a PLU code for each level. For example, if you want to
use this key as PLU code 1 (level 1) and PLU code 101 (level
2), enter 1 for “LEVEL1” and 101 for “LEVEL2.”
Key numbers
(ER-A280F)
NOTE
Procedure
▼
▼
▼
Direct Key Programming
Use the following procedure to select direct-key programming.
■ Direct key
You can assign departments and PLUs directly to the keyboard. In the case of PLUs, you may assign up to
3 levels to be accessed directly on the keyboard. For key no. positions, refer to the illustration shown below.
33 41
31 39
30 38
29 37
28 36
27 35
26 34
50 59
48 57
47 56
46 55
45 54
44 53
43 52
• You can assign departments and PLUs only the “Departments
and PLUs programmable area” shown above.
• You cannot assign a department or a PLU to the position to
which a function key has been assigned.
NOTE
(ER-A280N)
: Departments and PLUs programmable area
20 26
19 25
18 24
17 23
33
32
31
30
ER-A280F_N(SEEG)(E)-6 09.6.18 6:53 AM Page 114