Bosch Bottom Freezer I - Manual (Page 30)

30
q Insert the cover plate on the freezer compartment
door.
27. Mounting of air separator
Screw the air separator to the furniture door in order to
separate the supply and waste air.
q Shorten the air separator to the required length.
q Attach the air separator with the 2 clamps.
Align the air separator with the center line of the
door as illustrated in the diagram.
q The air separator must be cut out in the area of the
hose.
q Slowly close the door. Check whether the air
separator collides with parts of the ventilation grille.
If required, shorten the longitudinal side of the air
separator by approx.
1 /
4
" (6 mm).
28. Adjusting the door opening
angle
Depending on the installation situation, it may be
necessary to adjust the door opening angle. A door
opening angle of 115° has been set at the factory.
To adjust the door opening angle to 90°:
q Open door to 90°.
q Insert the banking pin through the boreholes which
are now vertically aligned and drive in with
a hammer.
29. Changing the door spring
To adjust the door spring:
q Rotate the adjusting screw with a crossĆhead
screwdriver.
I = maximum spring tension
0 = no spring tension