Bosch Bottom Freezer I - Manual (Page 17)

17
10. Installing and aligning the
appliance
q Align the appliance with the furniture fronts.
Place markingĆout level over the installation aid
parts on the door.
i The installation aid parts on the door have been
designed for the following total thickness of furniture
doors:
-
3 /
4
" (19 mm)
- 1 1 /
2
" (38 mm)
Always take account of the possible differing
thickness of the furniture fronts which are to be
fitted subsequently.
The heightĆadjustable feet at the front and rear can all
be adjusted from the front.
Front: with openĆended wrench 1 /
2
" (SW13)
Rear: with 5 /
16
" (8 mm) hex nut driver
via flexible shaft.
d CAUTION d
Never use a cordless screwdriver!
A mark is attached to the appliance base and is used as
a standard gage for height adjustment. When adjusting
the height, align this mark at a height of 1
1 /
4
" (32 mm)
above the floor.
q Unscrew the heightĆadjustable feet until the mark
on the base has reached the indicated guide
dimension (1
1 /
4
" / 32 mm).
i It is very important to comply with this dimension for
the subsequent alignment of the furniture fronts.
q Align the furniture fronts with the spirit level.
i Note:
- Do not twist or jam the appliance inside the cavity!
When unscrewing the heightĆadjustable feet,
proceed gradually: Always alternate between left
and right, left and right, etc..
- The adjustment of the rear feet is facilitated if the
appliance is unloaded at the rear.
- If using a wooden beam as an alternative antiĆtip
device according to point 5 of this installation
manual, rotate the appliance all the way towards
the wooden beam.