Bosch Bottom Freezer I - Manual (Page 12)

12
Installation instructions
1. Checking the installation cavity
d CAUTION d
To ensure a safe, troubleĆfree installation and an
optimum overall view of the subsequent furniture
front, thoroughly check that the installation cavity
complies with the installation requirements.
Before starting the installation, check that the installation
cavity complies with all requirements for a safe and
troubleĆfree installation.
q Check the base.
Follow the instructions in the section on Installation
location" on page 7.
q Check the dimensions of the cavity.
q Check that the cavity is square.
q Check location of the socket.
Also follow the instructions in the section on
Connecting the power" on page 8 and in the
section on Installation dimensions" on page 9.
q Check location of the water connection.
(only for appliances with ice maker)
Also follow the instructions in the section on
Connecting the water" on page 8.
q Check attachment of the adjacent furniture/fixtures.
All furniture parts in the vicinity of the appliance
must be connected securely to the wall.
q Check that adjacent furniture/fixtures do not collide
(door opening angle).
2.. Transport of the appliance
d CAUTION d
The appliance is very heavy. Be careful, otherwise
people who are helping may be injured or the
appliance may be damaged.
q Transport the appliance to a suitable installation
location with suitable means of transportation
(trolley, lifting truck or handĆdriven truck).
q Secure the appliance during transportation to
prevent it from overturning.
The appliance is 2134 mm tall. If the appliance cannot
be transported in an upright position due to the
structural conditions, the appliance can be transported
horizontally.
When erecting the appliance, observe the required
minimum height at the installation location according to
the following table:
Appliance width Erection via
appliance rear Erection via
appliance side panel
36" / 914 mm 86" / 2185 mm 91 1 /
4
" / 2315 mm
3. Removing the packaging
d WARNING d
- The appliance may tip over while it is being
unpacked.
- The appliance is very heavy.
- When opening the appliance door, the appliance
may tip forwards.
Be careful, otherwise people who are helping may be
injured or the appliance may be damaged.
To protect the base from damage during installation:
q Attach a residual piece of carpet, lino, etc. to the
floor with adhesive tape in front of the intended
installation location.
q Move the appliance with a hand truck securely.