Bosch Bottom Freezer I - Manual (Page 21)

21
16. Preparing the furniture doors
! IMPORTANT NOTE !
When performing any work on the furniture doors,
always observe the following:
- Always screw into the best loadĆbearing material
of the furniture door.
- Select a screw length which is always shorter than
the thickness of the furniture front.
- To prevent damage, protect surfaces of the
furniture doors during installation.
The total weight of the furniture front must not
exceed the following values:
BM 36" (top, 2 doors)
11 lbs / 5 kg (per door)
BM 36" (bottom) 22 lbs / 10 kg
The furniture fronts are attached to the appliance door
by means of fitting parts on the appliance. These fitting
parts allow the furniture door to be adjusted precisely
and attached securely to the appliance.
4.
Function of different parts:
1. Double threaded bolt on the adjusting rail:
for vertical adjustment of the furniture door.
2. Side brackets:
for adjusting the depth of the furniture front.
3. Nuts on the double threaded bolt:
for securing the furniture front to prevent lateral
movement.
4. Lower brackets (installation kit):
for securing the furniture front to prevent lateral
movement.
2 adjacent furniture doors can be attached instead of
one large door. These furniture doors must be
connected to a metal strip on the rear.
This metal strip can be purchased from customer
service as an optional accessory, see the section on
Optional accessories" on page 11.
When attaching the metal strip to the furniture doors,
observe the maximum possible length of the screws and
the position of the drill holes. Always screw into the best
loadĆbearing material of the furniture door.
Never screw into fillers, decorative strips or similar.
i If only one furniture door is to be attached to the
door of a 30" or 36" wide appliance, attach the
supplied sandwich plate to the adjusting rail and
lock into position.