Bosch Bottom Freezer I - Manual (Page 13)

13
q Remove transportation packaging:
- Remove the cartoon. Use the cutter securely to
protect the surface of appliance.
- Take supplied accessories out of protection
parts of packaging.
d CAUTION d
Do not remove transportation safety devices which
protect the shelves and storage compartments inside
the appliance until the installation is complete,
otherwise the parts may be damaged.
q Check appliance for damage in transit.
Do not install the appliance if it is visibly damaged.
If in doubt, contact your dealer.
4. Preparing the appliance
q Remove the side brackets and fixing plates which
attach the furniture fronts.
To do this, loosen the fastening screws and remove
the stop parts.
i Store the stop parts in suitable receptacles,
otherwise they may get lost.
5. Preparing the installation cavity
i 2 antiĆtipĆbrackets are required for each appliance.
q Specify the attachment points of the
antiĆtipĆbrackets.
Specify the detailed dimensions according to the
section on Installation dimensions" starting on
page 9.
d WARNING d
Assure that there are no electrical wires or plumbing
in the area which the screws could penetrate - risk of
injury and damage!
q If the installation cavity is deeper than the appliance,
place a solid wooden beam behind the
antiĆtipĆbrackets and attach securely to the base or
the wall.
The length of the wooden beam is equal to the
width of the installation cavity!
! IMPORTANT NOTE !
If possible, always screw the wooden beam to
existing studs on the rear panel of the cavity.
In some installations the subĆflooring or finished floor
may necessitate angling the wood screws used to
fasten the antiĆtipĆbrackets to the back wall.
i Important information for secure attachment of the
antiĆtip brackets:
- The supplied set contains fastening screws for
various applications. Select the fastening screws
according to the local conditions.
- If the supplied fastening screws do not permit
secure attachment of the antiĆtip brackets and
therefore the appliance, another method must
be used to attach the antiĆtip brackets securely.