Barco RLM R6+ PERFORMER R9010270 - Manual (Page 141)

14. Installation menu
Image 14-15
14.8 Automatic startup
What can be done ?
The automatic startup allows immediate restart of the projector after a power failure (breakdown), i.e. without passing through the
standby state.
The projector restarts at power resume and recovers the previous settings (previous source,...).
This function can be disabled if undesired or inadequate for safety reasons, etc.
C AUTION : If the Automatic startup function is enabled one must be aware of the fact that it involves safety
precautions
Make sure that the projector (or the operators!) will not be affected by altered environmental conditions when
restarting at power resume.
How to enable/disable the Automatic startup?
1. Press MENU to activate the menu bar.
2. Press → to select the Installation item. (image 14-16)
3. Press ↓ to pull down the Installation menu.
4. Use ↑ or ↓ to select Automatic startup .
5. Press → to pull down the menu.
6. Use ↓ or ↑ to enable/disable the automatic startup.
On Automatic startup enabled
Off Automatic startup disabled
7. Press ENTER to confirm.
Image 14-16
R5976816 RLM R6+ PERFORMER 02/06/2006 137