Nokia C6-00 - Manual (Page 48)

Authentication — To always send your
password encrypted, select Secure . To
send your password encrypted when
possible, select Normal .
Homepage — Depending on the access
point you are setting up, enter the web
address or the address of the multimedia
message center.
Use access point — Set the device to
connect to the destination using this
access point after confirmation or
automatically.
Modify advanced GPRS access point
settings
Select Options > Advanced settings .
Select from the following:
Network type — Select the internet
protocol type to transfer data to and from
your device. The other settings depend on
the selected network type.
Phone IP address (for IPv4 only) — Enter
the IP address of your device.
DNS addresses — Enter the IP addresses
of the primary and secondary DNS servers,
if required by your service provider. To
obtain these addresses, contact your
internet service provider.
Proxy server address — Enter the
address of the proxy server.
Proxy port number — Enter the port
number of the proxy server.
Wi-Fi internet access points
Select Menu > Settings and
Connectivity > Destinations > Access
point , and follow the instructions.
To edit a wireless LAN (WLAN) access
point, open one of the access point
groups, and select an access point marked
with .
Follow the instructions from your Wi-Fi
service provider.
Select from the following:
Wi-Fi network name — Select Enter
manually or Search for networks . If you
select an existing network, WLAN network
mode and WLAN security mode are
determined by the settings of its access
point device.
Network status — Define whether the
network name is displayed.
Wi-Fi network mode — Select Ad-hoc
to create an ad hoc network and to allow
devices to send and receive data directly;
a WLAN access point device is not needed.
In an ad hoc network, all devices must use
the same WLAN network name.
Wi-Fi security mode — Select the
encryption used: WEP , 802.1x , or WPA/
WPA2 (802.1x and WPA/WPA2 are not
available for ad hoc networks). If you
select Open network , no encryption is
used. The WEP, 802.1x, and WPA functions
can be used only if the network supports
them.
Homepage — Enter the web address of
the starting page.
Use access point — Set the device to
create a connection using this access point
automatically or after confirmation.
Available options may vary.
View your active data connections
Select Menu > Settings and
Connectivity > Connection mgr. .
In the active data connections view, you
can see your data connections:
data calls
packet data connections
WLAN connections
© 2010 Nokia. All rights reserved. 48