Toshiba Portege M750 - Manual (Page 80)

3-30 User’s Manual
PORTÉGÉ M750
Figure 3-13 Replace the keyboard
14. Set the keyboard brace into its groove and hold down to secure the
latches.
15. Install the battery pack. Refer to Replacing the battery pack section in
Chapter 6, Power and Power-Up Modes , for details.
16. Turn your computer over.
17. Turn the computer on and make sure the added memory is recognized -
to confirmed it, Start -> Control Panel -> System and Maintenance ->
System icon.
Removing a memory module (Slot A)
To remove the memory module, follow the steps as detailed below:
1. Set the computer to Boot Mode and turn its power off - make sure the
Power indicator is off (refer to the Turning off the power section in
Chapter 1, Getting Started , if required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Turn the computer upside down and remove the battery pack (refer to
Replacing the battery pack section in Chapter 6, Power and Power-Up
Modes , if required).
4. Follow steps 4 through 9 in Installing a memory module (Slot A) to
appear the memory module.
5. Push the latches to the outside to release the memory module. A spring
will force one end of the memory module up.
Keyboard
Screws
Tabs
The slot A is reserved for main memory. Use the slot B for expanded
memory. If only one card is installed, use the slot A.