Toshiba Portege M750 User Manual
Page 196
7-6
User’s Manual
PORTÉGÉ M750
CPU
This function allows you to set the processor’s operating mode.
Dynamic CPU Frequency Mode
This option allows you to configure the power saving modes associated
with the processor. The following settings are available:
LAN
Wake-up on LAN
This feature lets the computer’s power be turned on when it receives a
wake-up signal from the LAN.
Power will be automatically turned on when a signal is received from an
administrator’s computer which is connected via a network.
The following settings can be changed when the Built-in LAN is
Enabled
.
Connect the AC adaptor when using the Wake-up on LAN function. The
battery retention time will be shorter than the times listed in this manual
when this function is enabled. Refer to the section in chapter 6,
Dynamically
Switchable
The processor’s power consumption and
automatic clock speed switching functions are
enabled - in use the processor’s operation is
automatically switched when necessary (default).
Always High
The processor’s power consumption and
automatic clock speed switching functions are
disabled - in use the processor will always run at
its highest level of power consumption and its
highest speed.
Always Low
The processor’s power consumption and
automatic clock speed switching functions are
disabled - in use the processor will always run at
a lower level of power consumption and a low
speed.
Do not install or remove a memory module while Wake-up on LAN is
enabled.
■
The Wake-up on LAN function consumes power even when the system
is off. Leave the AC adaptor connected while using this feature.
■
To enable it, you must check both the “Allow the device to wake the
computer” and “Only allow management stations to wake the
computer” check box within the “Intel Network Connection”.
Enabled
Enables Wake-up on LAN (Default).
Disabled
Disables Wake-up on LAN.