Toshiba Portege M750 - Manual (Page 76)

3-26 User’s Manual
PORTÉGÉ M750
Installing a memory module (Slot A)
To install a memory module, follow the steps as detailed below:
1. Set the computer to Boot Mode and turn its power off - make sure the
Power indicator is off (refer to the Turning off the power section in
Chapter 1, Getting Started , if required).
2. Remove the AC adaptor and all cables and peripherals connected to
the computer.
3. Turn the computer upside down and remove the battery pack (refer to
Replacing the battery pack section in Chapter 6, Power and Power-Up
Modes , if required).
4. Turn your computer over.
5. Open the display panel so that the screen faces directly upward.
6. Slip your finger under a notch at the end of the keyboard brace and lift
up to release latches and remove the keyboard brace.
7. Remove two screws securing the keyboard.
Figure 3-8 Removing the keyboard brace and two screws
Use a point size 0 Phillips screwdriver.
Keyboard brace
Screws