Toshiba Qosmio X500 - Manual (Page 101)

User’s Manual 4-27
Operating Basics
■ When writing to a DVD-R/-RW, DVD+R/+RW or DVD-RAM disc, some
disc space is required for file management, so you may not be able to
write the full capacity of the disc.
■ Since the disc is based on the DVD standard, it might be filled with
dummy data if the written data is less than about 1 GB. Even if you write
only a small amount of data, it might take time to fill in the dummy data.
■ DVD-RAM formatted by FAT32 cannot be read in Windows 2000
without DVD-RAM Driver Software.
■ When multiple drives that can write data to discs are connected, be
careful not to write to the wrong drive.
■ Be sure to connect the AC adaptor before you write or rewrite.
■ Before you enter Sleep Mode/Hibernation Mode, be sure to complete
DVD-RAM writing. Writing is complete if you can eject the DVD-RAM
media.
■ Be sure to close all other software programs except the writing
software.
■ Do not run software such as a screen saver, which can put a heavy load
on the CPU.
■ Operate the computer under the power scheme High Performance. Do
not use power-saving features.
■ Do not write while virus check software is running. Wait for it to finish
and then disable virus detection programs including any software that
checks files automatically in the background.
■ Do not use hard disc utilities, including those intended to enhance HDD
access speed. They may cause unstable operation and data damage.
■ CD-RW (Ultra speed) media should not be used as data may be lost or
damaged.
■ Write from the computer's hard disc drive to the CD/DVD. Do not try to
write from shared devices such as a LAN server or any other network
device.
■ Writing with software other than Corel Digital Studio for TOSHIBA is
not recommended.
When writing or rewriting
Please observe/consider the following when you write or rewrite to a CD-R/
-RW, DVD-R/-RW/-RAM, DVD+R/+RW, or BD-R/-RE disc.
■ Do not perform any of the following actions when writing or rewriting:
■ Change users in the Windows
®
7 operating system.
■ Operate the computer for any other function, including using a
mouse or TouchPad or closing/opening the LCD panel.
■ Start a communication application such as a modem.
■ Apply impact or vibration to the computer.
■ Install, remove or connect external devices, including the following:
ExpressCard, USB devices, external display, optical digital devices.