Toshiba Qosmio G20 (PQG21) - Manual (Page 79)

User’s Manual 4-11
Operating Basics
Data Verification
To verify that data is written or rewritten correctly, follow the steps below
before you write or rewrite a Data CD/DVD.
1. Click the Options button( ) on the RecordNow! Console to open the
Options panels.
2. Select the Data in the left-side menu.
3. Mark the Verify data written to the disc after burning check box in the
Data Options.
4. Click the OK button.
DLA for TOSHIBA
Note the following limitations when you use DLA:
■ This software supports only rewritable discs (DVD+RW, DVD-RW, and
CD-RW). It does not support DVD+R, DVD-R, and CD-R discs that are
not rewritable.
■ DLA does not support formatting a DVD-RAM disc and writing to it, this
function is performed by DVD-RAM Driver Software. You may find that
the DLA Format menu appears when inserting a DVD-RAM disc,
although you should use the “DVDForm” utility to format this disc.
You can run “DVDForm” by clicking the Start button and then selecting
“All Programs”,
■ “DVD-RAM”, “DVD-RAM Driver” and “DVDForm” sequentially.
■ Do not use any discs that have been formatted with packet writing
software other than DLA. Similarly, do not use any discs that have been
formatted with DLA with any packet writing software other than DLA.
When using a disc you are not familiar with, format it by selecting
“Full Format” before using it.
■ Do not use the cut -and-paste function for files and folders. A file or
folder that has been cut may be lost if writing fails due to an error on the
disc.
■ When writing SETUP files for an application to a disc formatted by DLA,
and then attempting to start SETUP from this disc, an error may occur.
In this case, please copy the SETUP files to the hard disk and then run
them from there.