Toshiba Magnia 7100 User Manual
Page 75

63
HW Diagnostics
SCSI HDD TEST
SCSI HDD TEST (HDD)
Status
Error name
Meaning
01
CHECK CONDITION OR BAD COMAND
Bad command error
03
DRIVE SELECTION FAILED
ID selection error
04
TARGET DRIVE BUSY
The target drive is busy
05
SCSI BUS TIME OUT
Time out error of SCSI bus
09
DMA BOUNDARY ERROR
DMA BOUNDARY occurred
0D
COMMAND TERMINATED
A command terminated
0E
QUEUE FULL
Command queue is full
80
NO SENSE
The sense data is invalid
81
RECOVERD ERROR
The execution of the command has
correctly finished because of
recovery treatment.
82
NOT READY
The condition does not satisfy for
the command execution
83
MEDIUM ERROR
An error occurred because of the
failure of a medium
84
HARDWARE ERROR
A hard error that is impossible
to recover occurred during
command execution
85
ILLEGAL REQUEST
CBD is illegal
86
UNIT ATTENTION
The function of hard disk drive has
been changed
87
DATA PROTECT
Data protection error
89
VENDOR UNIQUE
A unique error of disk maker
8A
COPY ABORTED
Stop of COPY command
8B
ABORTED COMMAND
The execution of a command
is correctly stopped
8C
EQUAL
The comparing result of the
search data command is
satisfied
8E
MIS COMPARE
Comparing command error
E0
STATUS ERROR
Status error
F0
OTHER ERROR
Other errors
FE
NO DRIVE ERROR
The target drive has not been found
FF
DATA COMPARE ERROR
Data comparing error
NOTE: The [01. Sequential address read] tests all areas of the hard disk drive. If the capacity of
installed hard disk drives are large enough, the test may take a few hours.
If you do not know where the hard disk drives are connected (host ID, SCSI ID and channel number
of the SCSI controller), you can find them from [01.INQUIRY] of [09.SCSI TEST].