Toshiba Magnia 7100 User Manual

Page 63

HW Diagnostics
Starting from the Utility Partition

Starting from the Utility Partition

1. Switch on the server.

When the system reboots, the following message appears; press + .

2. When the Utility Partition is activated, the following message appears:

Utility Partition is successfully activated.

3. Select "Utility" option from the SST [Main Menu] screen.
4. Select [HW Diagnostics] option.

After the completion of the test, close the 'HW Diagnostics Program'. The Toshiba 'Server
Setup TooL' menu appears again after rebooting.

NOTE: To start the HW Diagnostics Program from the diskette, create the HW Diagnostics Program
diskette from the “Create Floppy Disks” menu in the SST.

SMC BIOS xxx.xx.xxx

Key is accepted. (*)

Input + keys

within four seconds after

the appearance of the message.

NOTE: If disk access fails, the following message appears:

Error detected. Utility Partition is not activated.
If the Utility Partition does not exist, the following message appears:
Utility Partition is not found.

NOTE: To finish the HW Diagnostics Program started from the Utility Partition, select [Main Menu] –
[Exit] of the Server Setup TooL.